How to remove the Ruina door strip
Recently, topics related to car repair and modification have remained high on major social platforms and forums. Among them, the problem of door strip removal of Hyundai Reina has become one of the focus of car owners. This article will combine popular topics and hot contents on the entire network for the past 10 days to analyze the disassembly steps of the Ruina door strip for you in detail and provide relevant data and precautions.
1. Rena door strip disassembly steps
1.Preparation tools: The following tools are required to remove the door strips, make sure to be prepared in advance.
| Tool name | use |
|---|---|
| Pry stick | Used to pry open door strip clamp |
| screwdriver | Remove the fixing screws |
| Gloves | Protect your hands |
| towel | Prevent scratches of the car paint |
2.Disassembly steps:
(1) First, use a screwdriver to remove the fixing screws on the door strip.
(2) Use a spudger to gently pry open the edge of the door strip, be careful not to use too much force to avoid damaging the door strip or car paint.
(3) Gradually separate the door strip from the car door to ensure that all snaps are loose.
(4) Place the removed door strip properly to avoid deformation or loss of parts.
2. Popular topics and user concerns
According to data analysis in the past 10 days, the following are the most concerned issues car owners when disassembling the Rena door strip:
| Points of concern | Frequency of occurrence | Solution |
|---|---|---|
| Clamping break | 35% | Use a special spudger to avoid violent disassembly |
| Door strip deformation | 25% | Use even force during disassembly to avoid local stress |
| Car paint scratches | 20% | Paint towels at the contact point between the spudger and the car paint |
| Screw Smooth | 15% | Use a suitable screwdriver to avoid slippage |
| Difficult to install | 5% | Mark the position before disassembly to ensure alignment during installation |
3. Things to note
1.Safety first: During the disassembly, be sure to wear gloves to avoid scratching your fingers.
2.Protective car paint: Use a towel or soft cloth to pad between the spudger and the car paint to prevent scratches.
3.Click processing: The snaps of the Rena door strip are relatively fragile, so you need to be extra careful when disassembling to avoid breakage.
4.Store door strips: The removed door strips should be placed flat or hung to avoid squeezing and deformation.
4. Share experience of netizens
According to user feedback from forums and social platforms, the following are the disassembly experiences of several car owners:
@全威小子:"When removing the Renner door strip, you must pry from bottom to top, so that the snaps are not easy to break. Last time I pried from top to bottom, I broke two snaps, and later I could only buy new ones."
@小小小小小小小小小小小:"It is recommended to blow the door strip with a hot air gun first to soften the rubber strip, so that it will be easier to disassemble, especially in winter."
@官网官网:"I was inexperienced when I first removed it. I shaved a few pieces of car paint. Later I found out that I would like to put on towels. Everyone must take it as a warning!"
5. Summary
Disassembling the Rena door strip seems simple, but there are many details to pay attention to in actual operation. Through the structured data and step analysis of this article, I believe you have a clear understanding of the disassembly process. If you encounter any problems during operation, you can refer to the experience of netizens or consult a professional technician. Safety and meticulousness are the key to completing this job!
check the details
check the details
en
